Top 10 common forklift mishaps ， forklift operation ought to take note of these matters ！.

Don't take too lightly the forklift at the office. If the operation is not good, there will be significant accidents in minutes, and there are numerous mishaps entailing forklifts.

Situation 1: The forklift freight obstructed the motorist's view, and the individual ahead can not be located, causing a moving crash.
Instance 2: In order to keep the equilibrium of the forklift when raising heavy goods, the employees used their body weight as the counterweight, which practically caused casualties.
Case 3: The size of the forklift freight surpasses the permitted width of the route and holds on the roadside shelf, which almost causes an crash.
Situation 4: Forklift is speeding and surrender during a turn.
Case 5: The forklift driver did not notice the pedestrian, and the pedestrian did not see the forklift.
Situation 6: The forklift lifts the employees unlawfully, the forklift chauffeur does not wear the safety belt, the forklift lifter falls and the vehicle driver is crushed when the forklift surrender.
Case 7: The forklift vehicle driver did not use a seat belt and dropped from the vehicle when it surrendered and was crushed.
Forklift operation should take notice of these matters ：.

Beginning.
1. Before beginning, observe the environments, and after confirming that there are no challenges that prevent the safety of driving, honk the horn first and afterwards begin.
2. For cars with hydraulic ( atmospheric pressure) brakes, the brake hydraulic stress (air pressure) gauge have to be safe before starting.
3. When the forklift starts with a lots, the chauffeur must initially validate that the lots is stable and trustworthy.
4. The beginning must be slow and stable.

Driving.
1. When driving, the height in between the bottom end of the fork and the ground need to be maintained 300mm-400mm, and the pole should be tilted backwards. .
2. Do not lift the fork expensive when driving. When getting in and leaving the job site or while driving, beware that there will certainly be no barriers overhead. When the load is traveling, the fork should not be increased too expensive, which will impact the stability of the forklift. .
3. After discharging, the fork must be decreased to the regular driving placement before driving. .
4. When transforming, if there are pedestrians or lorries close by, the driving signal needs to be released initially. High-speed doglegs are forbidden. High-speed doglegs will certainly create the automobile to shed lateral stability and topple. .
5. When the forklift is downhill, it is strictly restricted to shut off the fire and slide, and it is prohibited to brake unexpectedly while driving with tons unless there are special situations.
6. When the forklift is running, it should obey the website traffic rules in the factory and have to keep a certain safety and security range from the car ahead. .
7. When the forklift is running, the tons must be in the lowest position that does not hinder the driving, and the gantry must be correctly slanted back. The lots shall not be elevated except when stacking or filling. .
8. The height of the load need to not obstruct the chauffeur's view. In special scenarios, when the item impacts the forward vision, drive at a low rate when reversing.
9. It is restricted to switch on the ramp, nor to drive throughout the ramp. .
10. The secure driving rate of the forklift in the factory area is 5 km/h, and it needs to drive securely at a low speed when going into the manufacturing workshop location. .
11. When the forklift is lifted, lifted or driven, it is forbidden for workers to depend on the fork to hold things and play a balancing function. .
12. If troubles are located, they will certainly be fixed and reported in a prompt fashion, and they will certainly never Electric Forklift Truck for Warehouse run with diseases or conceal them.

packing and discharging.
1. When fork-loading products, the range between the two forks must be changed as required Electric Forklift Truck for Warehouse to make the lots of the two forks balanced and not skewed, and one side of the item ought to be against the rack. .
2. It is forbidden to work with a single fork or make use of a fork top or draw. In unique scenarios, security indication must be set up to remind bordering pedestrians. .
3. In the process of filling and dumping items, the forklift should be braked with the brake. .
4. The rate of the lorry need to be slow and stable. Beware not to roll the wheels on the dunnage, so as not to extend the rolled things and harm individuals. .
5. When making use of a fork to fork the goods, the fork needs to be as deep as possible under the lots, and it ought to be noted that the fork pointer ought to not touch other items or items. The lots ought to be stabilized with marginal back tilt of the gantry to ensure that the lots does not move in reverse. The mast can be tilted onward slightly when the lots is lowered to permit simple positioning of the load and removal of the forks. .
6. It is forbidden to fork goods at high speed and ram hard items with the fork head. .
7. When the forklift is functioning, it is prohibited for individuals to stand around the fork, so as to stay clear of the collapse of the goods and hurt people. .
8. Straining is restricted, and it is banned to make use of forks to lift personnel to take part in high-altitude procedures to avoid high-altitude falling mishaps. .
9. It is not enabled to use the brake inertia to slide, put, round or roll objects. .
10. It is not enabled to utilize forks to choose, transform pallet discharge.

Leaving .
1. It is restricted to leave the forklift when the things on the fork are in the air. Before leaving the forklift, you need to discharge the goods or reduced the fork structure.
2. Draw the hand brake handle to dead or depress the hand brake button.
3. The engine is switched off and the power is removed. (Except for unique conditions, such as the driver does not leave the lorry's line of sight and does not go beyond 1 min).
4. Get rid of the secret. .

Forklift Operation Precautions.
1. Prior to and after the forklift operation, the appearance should be checked, and gas, lubing oil and air conditioning water ought to be added.
2. Check the safety and security efficiency of starting, running and braking.
3. Examine whether the lights and horn signals are total and effective.
4. Throughout the procedure of the forklift, check whether the stress and temperature level are normal.
5. After the forklift is running, the external leak ought to also be examined and the seals need to be replaced in time.

Forklift Safety Operation Specifications.
1. You should check before leaving the automobile;.
2. When you experience a person in front of you throughout driving, you must send a signal at a distance of 5 m;.
3. The driving rate in the factory does not go beyond 5 km/h;.
4. When driving, the low point of the freight ought to be 0.3 m ~ 0.4 m in the air;.
5. The turning need to not be too sharp to stop the tendency of " cost-free turning";.
6. Adding and down the incline must be slow-moving and uniform, and no activating the slope is enabled.
7. Do not drive throughout the gradient. When the gradient is more than 10%, the car must be driven in reverse when going downhill;.
8. When the forklift workers lug the goods and move forward, if they come across large or heavy products and most likely to the vehicle driver's line of sight, they must take the turning around workout
.
The "Eight Prohibitions" should be complied with in the procedure.
1. Solitary fork procedure is not permitted.
2. It is not allowed to lift the goods for far away driving.
3. It is not enabled to get the goods by passing on the pallet with the fork.
4. It is not permitted to straight shovel chemicals, flammables and various other unsafe chemicals with forks.
5. It is not allowed to use inertia force to pick up the goods.
6. It is not permitted to make use of stopping pressure to expatriation round or easy-to-roll items.
7. It is not enabled to bring individuals to work on the pallet or fork, and it is purely restricted to stand under the fork after the fork is elevated.
8. Do not drive side to side on slopes
.
Vehicle parking is not permitted under the following conditions.
1. Contours, slim roads, train crossings;.
2. Areas with a longitudinal slope higher than 5%.
3. When there is an obstacle on one side of the roadway, the contrary side of the section with the same size as the challenge ought to be within 20 meters at each end.

Web：https://www.onenforklifts.com/
Email：[email protected]
Phone：+86 13827083844